Carb Mockup

[Mr. Nobody]

I still have to get the head sent out and have it cleaned up as well as I am thinking I might want to rebuild the carbs, but looking over them they don't look to bad. I may be able to get away with them as is for now. That would be nice as then I could put the money towards better things.

I did the mockup mainly for a desktop photo to keep me focused. ha.

Keep in mind it is just a mockup so I did not put every bolt on so you don't need to point it out.

http://i33.photobucket.com/albums/d66/laminar/DSC02088.jpg
http://i33.photobucket.com/albums/d66/laminar/DSC02098.jpg
http://i33.photobucket.com/albums/d66/laminar/DSC02094.jpg
http://i33.photobucket.com/albums/d66/laminar/DSC02095.jpg

and who knows where I can get a pretty one of these? Stock one doesn't clear the carbs.

http://i33.photobucket.com/albums/d66/laminar/DSC02102.jpg

and it is all going into this little bastard.

http://i33.photobucket.com/albums/d66/laminar/DSC02104.jpg

[daygoVR6]

f'ing sweet dood....i want to do side drafts on a VR ...I already have the specs for it... muhahaha

[Mr. Nobody]

Never seen it on a VR. I have heard that the guy who did the durocco was looking into it.

[EDM]

I have seen ITB on a VR but not side drafts.
http://forums.vwvortex.com/zerothread?id=2498670

Have you tried these guys for the coolant neck?
http://rotaryracing.com/ff_watercooled.htm

[ncttrnl]

I hate you... only because thats going to be a sweet setup. :tup:


BTW you missed a bolt :p

[huitzi]

i have two questions where did you get those carbs and how much did you pay for them

[Mr. Nobody]

i have two questions where did you get those carbs and how much did you pay for them

I bought them off a friend, and way less than I should have. :p