Anyone know where I can get small plastic or chrome grommets?

[Rento_VW]

Hi guys, I have an idea for a little bit of glovebox fabrication so I can route RCA wires into my glovwbox. However, since the glovebox is $400, I want it to either look professional and OEM, or not cut at all.

So I was thinking of finishing the cut hole with a small grommet, preferably in black plastic, but chrome is a plus. Plastic might be easier to work with since i'm going to cut and sand the back of it to sit flush with the not visible side of the glovebox.

I searched the internet forever, could not find any... The smallest I could find is 1" inside diameter and no small rectangular grommets. However, there were these paper hole square grommets, I guess I could cut in half and than plastic weld the ends to a custom length.

Here is the sizes illustrated in MS paint! (These actual sizes are nice or something near them)

http://img80.imageshack.us/img80/1427/grommetsne5.png

[krakkaNW]

why would you need a hole to put rca's in there, cant wire behind the dash?? just wondering the logic behind it

[Streamline]

Just open up your front dash or wherever and wire it in the back. I spent 8 hours last weekend tearing out my entire interior. It's easier than it looks.

[RollinInGreenz]

your local hardware store should have rubber grommets, I know Home Depot has them...cabinet fittings section, near the drawer pulls and knobs...weird place, I know...but its where they keep all the little tiny odds/ends hardware shtuff...try not to laugh too hard when you see a drawer full of Bungs.

[cruzman]

You can try an electronics store as well. I doubt Radio Shack would have them, but a place like Frys and also an actual Electronics place that does repairs and carries supplies..in the OC area, Ball Electronics I know has them...well good luck..