apr snubmount

[myaudibaby]

ok... here's the question... how do i install it?? is it a PITA to install? definitly i have to jack up the car, right?

[bugzy]

its suppose to be a fairly easy mod ... supposally 30-45 min

[FunkTron]

just did a tad of reading on it.........

might wanna check out this install guide.......if its not the same.....it may at least be similar enough so you get the point. =o)

cheers!

http://www.goapr.com/Audi/support/b6_snub_mount.pdf

[audiracer2002]

depends whether you have a 1.8 or a 3.0. its easy on the 1.8 since there is a ton of room in front of the motor. on the 3.0 on the other hand, its a big pain in the ass. i have it on my 3.0 though and it was definitely a worthwhile mod!

[MikekiM]

It can be only a 15 minute install if you're good. :)

Check out our snub mount as well. A little less expensive with very good results.

[Gryphun]

Mike is your snub mount harder or softer than APR..i know its a tad smaller right?

[MikekiM]

It's a bit softer than APR, and smaller in diameter than theirs.

[bugzy]

just remember, if its too hard, it'll cause vibration ...

[audiracer2002]

the vibration can be avoided by starting the car and letting the mount center itself and settle before tightening everything all the way down. i have the apr snubmount, which is pretty hard, but don't have any vibration problems.

[myaudibaby]

ok. thanks for the input guys. i'll try to install it this weekend.

[YINucsd]

total n00b question here, is there a snubmount for the 98 2.8?

edit: nevermind i found it.

[DVS18t]

just remember, if its too hard, it'll cause vibration ...

thats all in the installer... i have the APR snub and it feels not different than stock the trick is to loosen the cradle and allow the snub to seat itself then tighten the bolts so that the snub is not touching at idle....